Kia Carens: Interior features / Air ventilation seat
The air ventilation is provided to cool the driver’s seat or front passenger's
seat during hot weather by blowing air through small vent holes on the surface of
the seat and seatback. While the engine is running, press the switch to cool the
seat.
When the operation of the air ventilation is not needed, keep the switches in
the OFF position.
- Each time you press the switch, the airflow will change as follows:
- When pressing the switch for more than 1.5 seconds with the seat cooler
operating, the seat cooler will turn OFF.
- When the air ventilation seat is turned on, the seat may get cooler after
about 5 minutes.
- Because the air ventilation uses the air in the vehicle, cooling efficiency
depends on the temperature of the air. In order to improve cooling efficiency,
use the air conditioning system together.
- The air ventilation seat defaults to the OFF position whenever the ignition
switch is turned to the ON position.
CAUTION - Seat damage
- When cleaning the seats, do not use an organic solvent such as paint
thinner, benzene, alcohol and gasoline. Doing so may damage the air ventilation
seat.
- Do not place heavy or sharp objects on the seat. Those things may damage
the air ventilation seat.
- Be careful not to spill liquid such as water or beverages on the seat.
If you spill some liquid, wipe the seat with a dry towel. Before using the air
ventilation seat, dry the seat completely.
- Do not change the seat cover. It may damage the seat warmer or airventilation
system.
The seat warmer is provided to warm the front seats during cold weather. With
the ignition switch in the ON position, push the switch to warm the seat.
During mild weather or under conditions where ...
Use the sunvisor to shield direct light through the front or side windows.
To use a sunvisor, pull it downward.
To use a sunvisor for a side window, pull it downward, unsnap it from the bracket
(1) ...
Other information:
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
3.
Install in the reverse order of removal ...
The indicator on the switch will illuminate when the BSD (Blind spot detection)
system switch is pressed with the ignition switch ON. If the vehicle speed exceeds
30 km/h (18.6 mph), the system will activate.
If you press the switch again, the switch indicator and system will be turned
off.
If t ...