Kia Carens: Brake system / Anti-lock brake system (ABS)
WARNING
ABS (or ESC) will not prevent accidents due to improper or dangerous driving
maneuvers. Even though vehicle control is improved during emergency braking, always
maintain a safe distance between you and objects ahead. Vehicle speeds should always
be reduced during extreme road conditions.
The braking distance for vehicle equipped with an anti-lock braking system
(or Electronic Stability Control) may be longer than for those without it in the
following road conditions. During these conditions the vehicle should be driven
at reduced speeds:
- Rough, gravel or snow-covered roads.
- With tire chains installed.
- On roads where the road surface is pitted or has different surface height.
The safety features of an ABS (or ESC) equipped vehicle should not be tested
by high speed driving or cornering. This could endanger the safety of yourself or
others.
The ABS continuously senses the speed of the wheels. If the wheels are going
to lock, the ABS system repeatedly modulates the hydraulic brake pressure to the
wheels.
When you apply your brakes under conditions which may lock the wheels, you may
hear a “tik-tik’’ sound from the brakes, or feel a corresponding sensation in the
brake pedal. This is normal and it means your ABS is active.
In order to obtain the maximum benefit from your ABS in an emergency situation,
do not attempt to modulate your brake pressure and do not try to pump your brakes.
Press your brake pedal as hard as possible or as hard as the situation warrants
and allow the ABS to control the force being delivered to the brakes.
✽ NOTICE
A click sound may be heard in the engine compartment when the vehicle begins
to move after the engine is started. These conditions are normal and indicate that
the anti-lock brake system is functioning properly.
- Even with the anti-lock brake system, your vehicle still requires sufficient
stopping distance. Always maintain a safe distance from the vehicle in front
of you.
- Always slow down when cornering. The anti-lock brake system cannot prevent
accidents resulting from excessive speeds.
- On loose or uneven road surfaces, operation of the anti-lock brake system
may result in a longer stopping distance than for vehicles equipped with a conventional
brake system.
CAUTION
- If the ABS warning light is on and stays on, you may have a problem with
the ABS. In this case, however, your regular brakes will work normally.
- The ABS warning light will stay on for approximately 3 seconds after
the ignition switch is ON. During that time, the ABS will go through selfdiagnosis
and the light will go off if everything is normal. If the light stays on, you
may have a problem with your ABS.We recommend that you contact an authorized
Kia dealer.
CAUTION
- When you drive on a road having poor traction, such as an icy road, and
operate your brakes continuously, the ABS will be active continuously and the
ABS warning light may illuminate. Pull your vehicle over to a safe place and
stop the engine.
- Restart the engine. If the ABS warning light is off, then your ABS system
is normal. Otherwise, you may have a problem with the ABS.We recommend that
you contact an authorized Kia dealer.
✽ NOTICE
When you jump start your vehicle because of a drained battery, the engine
may not run as smoothly and the ABS warning light may turn on at the same time.
This happens because of the low battery voltage. It does not mean your ABS is malfunctioning.
- Do not pump your brakes!
- Have the battery recharged before driving the vehicle.
If the EPB does not release normally, we recommend that you take your vehicle
to an authorized Kia dealer by loading the vehicle on a flatbed tow truck and have
the system checked. ...
The Electronic Stability Control (ESC) system is designed to stabilize the vehicle
during cornering maneuvers. ESC checks where you are steering and where the vehicle
is actually going. ESC applies ...
Other information:
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...
Replacement
[Removal]
•
In order to remove the panorama sunroof assembly, use the tools
shown in the following figure:
[Tooling Diagram]
...