Kia Carens: Seat belt restraint system / Lap belt
To fasten your seat belt:
To fasten a 2-point static type belt, insert the metal tab (1) into the locking buckle (2). There will be an audible "click" when the tab locks into the buckle. Check to make sure the belt is properly locked and that the belt is not twisted.
With a 2-point static type seat belt, the length must be adjusted manually so it fits snugly around your body. Fasten the belt and pull on the loose end to tighten. The belt should be placed as low as possible on your hips (1), not on your waist. If the belt is too high, it could increase the possibility of your being injured in an accident.
When using the rear center seat belt, the buckle with the “CENTER” mark must be used.
To release the seat belt:
When you want to release the seat belt, press the button (1) in the locking buckle.
WARNING
The center lap belt latching mechanism is different from those for the rear seat shoulder belts. When fastening the rear seat shoulder belts or the center lap belt, make sure they are inserted into the correct buckles to obtain maximum protection from the seat belt system and assure proper operation.
Lap/shoulder belt
Height adjustment
You can adjust the height of the shoulder belt anchor to one of 4 positions for
maximum comfort and safety.
The height of the adjusting seat belt should not be too close to your ne ...
3 Point rear center belt
To fasten the rear center belt
1. Detach the mini tongue from holder and then extract the tongue plate from
the hole on the belt assembly cover and slowly pull the tongue plates out from the
retrac ...
Other information:
Kia Carens RP (2013-2018) Owners Manual: FLEX STEER
The FLEX STEER controls steering effort as driver's preference or road condition. You can select the desired steering mode by pressing the steering mode button. When the steering mode button is pressed, the selected steering mode will appear on the LCD display. If the steering mode button is press ...
Kia Carens RP (2013-2018) Service Manual: Repair procedures
Inspection Component Inspection 1. Remove the clutch switch. (Refer to Clutch Switch - "Removal") 2. Push the clutch switch in the direction of the arrow to make sure that continuity is cut off. ...
