Kia Carens: Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.

2.	Without EFD - Remove the lower anchor bolt. Witht EFD - To remove the emergency fastening device (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3.	Remove the center pillar trim. (Refer to Body - "Center pillar trim")

4.	Remove the upper anchor bolt.

5.	Loosen the seat belt pretensioner mounting bolts (B) and remove the seat belt pretensioner.

6.	Disconnect the seat belt pretensioner connector (A).

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Install the seat belt pretensioner with a bolts (B).

Tightening torque

Bolt B:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.	Connect the seat belt pretensioner (BPT) connector (A).

Install the upper anchor bolts.

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

6.	Install the center pillar trim. (Refer to Body - "Center pillar trim")

Without EFD - Install the lower anchor bolts.

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

Witht EFD - Insert the seat belt to the emergency fastening device.

Make sure the lock pin is connected in properly.

8.	Reconnect the battery negative cable.

After installing the seat belt pretensioner, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Seat Belt Pretensioner (BPT) Components and components location

Components ...

Emergency Fastening Device (EFD) Description and operation

Description Front emergency fastening device operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Walk-in seat (2nd row seat, if equipped)

To get in or out of the 3rd row seat: 1. Routing the seat belt webbing through the rear seat belt guide clip. After inserting the seat belt, tighten the belt webbing by pulling it up. 2. Pull up the walk-in lever (1) on the 2nd row seatback. 3. The 2nd row seatback will be folded and push the seat ...

Kia Carens RP (2013-2018) Owners Manual: Dual clutch transmission operation

The dual clutch transmission has seven forward speeds and one reverse speed. The individual speeds are selected automatically in the D (Drive) position. WARNING To reduce the risk of serious injury or death: ALWAYS check the surrounding areas near your vehicle for people, especially children, be ...