Kia Carens: Engine start/stop button position / START/RUN

Kia Carens RP (2013-2018) Owners Manual / Driving your vehicle / ENGINE START/STOP button / Engine start/stop button position / START/RUN

With manual transaxle

To start the engine, depress the clutch pedal and brake pedal, then press the engine start/stop button with the shift lever in the N (Neutral) position.

With automatic transaxle / Dual clutch transmission

To start the engine, depress the brake pedal and press the engine start/stop button with the shift lever in the P (Park) or the N (Neutral) position. For your safety, start the engine with the shift lever in the P (Park) position.

✽ NOTICE

If you press the engine start/stop button without depressing the clutch pedal for manual transaxle vehicles or without depressing the brake pedal for automatic transaxle / dual clutch transmission vehicles, the engine will not start and the engine start/stop button changes as follow:

OFF ➔ACC ➔ ON ➔ OFF or ACC

✽ NOTICE

If you leave the engine start/stop button in the ACC or ON position for a long time, the battery will discharge.

CAUTION

If the driver takes foot off the clutch pedal of a manual transaxle vehicle before the engine is fully started, the engine may not start.

Make sure to fully depress the clutch pedal and brake pedal to start the engine.

WARNING

ON
With manual transaxle Press the engine start/stop button when the button is in the ACC position without depressing the clutch pedal. With automatic transaxle / Dual clutch transmission Press the eng ...

Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots,etc.) may interfere with your ability to use the brake, accelerator and clutch (if equi ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Steering Column Shroud Panel Repair procedures


Replacement [Steering column shroud lower panel]    • Put on gloves to protect your hands.    ...

Kia Carens RP (2013-2018) Owners Manual: Turn signal light


Follow the steps 1 to 2 from the previous page. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on ...

Copyright © www.kicaman.com 2015-2024