Kia Carens: Child restraint system / Using a child restraint system

For small children and babies, the use of a child restraint system is required.
The child restraint system should be of appropriate size for the child and should
be installed in accordance with the manufacturer's instructions.
For safety reasons, we recommend the child restraint system to be used in the
rear seats.
WARNING
Never place a rearward facing child restraint system in the front passenger
seat, unless the passenger frontal airbag is deactivated. An inflating passenger
frontal airbag could impact the rearward facing child restraint system and kill
the child.
WARNING

Always remove floor under tray cover when using a child restraint seat with
support leg on second row outboard seating position.
Support leg should have to contact stably on the vehicle floor.
WARNING
- A child can be seriously injured or killed in a collision if the child
restraint system is not properly anchored to the vehicle and the child is not
properly restrained in the child restraint system. Before installing the child
restraint system, read the instructions supplied by the child restraint system
manufacturer.
- If the seat belt does not operate as described in this section, we recommend
the system to be checked by an authorized Kia dealer.
- Failure in observing this manual's instructions regarding child restraint
systems and the instructions provided with the child restraint system could
increase the chance and/or severity of injury in an accident.
- Temporarily re-adjust or remove any headrest interfering with the proper
installation of child restraint system. Make sure to put any removed headrests
back into position for adult occupants.
Children riding in the vehicle should sit in the rear seat and must always be
properly restrained to minimize the risk of injury in an accident, sudden stop or
sudden maneuver. According to accident ...
To install a child restraint system on the seat, do the following:
1. For stable and safe installation of child restraint system, adjust the vehicle
seat (seatback angle and/or seat forward and back ...
Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistance between terminal “+” and “-” of the evaporator
temperature sensor. ...
This indicator light illuminates for up to 30 seconds:
• When the vehicle detects the smart key in the vehicle properly while the Engine
Start/Stop Button is ACC or ON.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.
This indicator light blinks ...