Kia Carens: Towing / General information
If the vehicle needs to be towed, call a professional towing service. Never
tow vehicle with just a rope or chain. It is very dangerous.
Emergency Towing
There are three popular methods of towing a vehicle :
– |
The operator loads the vehicle on the back of truck. This is best way
of transporting the vehicle.
|
– |
The tow truck uses two pivoting arms that go under the tires of the
driving axle and lift them off the ground. The other two wheels remain
on the ground.
|
– |
The tow truck uses metal cables with hooks on the ends. These hooks
go around parts of the frame or suspension, and the cables lift that
end of the vehicle off the ground. The vehicle's suspension and body
can be seriously damaged if this method of towing is attempted.
|
If the vehicle cannot be transported by flat-bed, should be towed with the wheels
of the driving axle off the ground and do the following :
Manual Transaxle
• |
Release the parking brake.
|
• |
Shift the Transaxle to neutral
|
Automatic Transaxle
• |
Release the parking brake.
|
• |
Shift to [D] position, then [N] position.
|
• |
The vehicle equipped with full-time 4WD should be only transported
on a flat-bed.
|
• |
Improper towing preparation will damage the transaxle. follow
the above procedure exactly. If you cannot shift the transaxle
or start the engine(automatic transaxle), your vehicle must
be transported on a flatbed.
|
• |
It is the best to tow vehicle no farther than 30km (19miles),
and keep the speed below 50km/h (30mph). (For the full-time
4WD vehicle, limit the towing to 1.5km (1mile) and 15km/h (10mph)
|
• |
Trying to lift or tow your vehicle by the bumpers will cause
serious damage. The bumpers are not designed to support the
vehicle's weight.
|
|
Other information:
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T.
and W.O.T.
Specification: Refe ...
Components
1. Battery insulation pad
2. Battery
3. Battery tray
4. Battery mounting bracket
...