Kia Carens: Power Door Locks / Power Door Lock Actuators Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Actuators Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table.

Rear Door Lock Module Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear door module. (Refer to Body - "Rear Door Module")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table.

Tailgate Lock Module Inspection

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the 4P connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the 4P connector from the actuator.

3.	Check for continuity between the terminals in each switch position according to the table.

Hood Switch

1.	Disconnect the connector (A) and bolts from the hood switch.

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn

1.	Remove the burglar horn after removing a bolt and disconnect the 2P connector from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should sound. If the burglar horn fails to sound replace it.

Components and components location

Component Location 1. Driver power window main switch 2. Center fasicia door lock switch 3. BCM (Body Control Module) 4. Door lock switch 5. Tailgat ...

Power Door Lock Switch Repair procedures

Diagnosis With GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Blind spot detection system (BSD)

The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD(Blind spot detection) Warning range is dependent on your vehicle speed. However, if the speed of your vehi ...

Kia Carens RP (2013-2018) Service Manual: Rear Pillar Trim Components and components location

Component Location 1. Rear pillar trim ...